H&S XRT Pro, Руководство по установке и эксплуатации

Страница: 25 / 32

1-888-628-1730 • XRT Pro Installation Manual 25
2007-2010 6.6l lMM DUraMaX
Usa / UlsD caliBraTion
Power levels
Power Levels can be adjusted on-the-fly at the touch of a
button after Installing the Download to the vehicle. To adjust
the Power Level, select
change Power level from the Main
Menu.
noTe: The Power Level ratings listed may not be exact for your particular
vehicle. The listed ratings apply to the out-of-the-box tuning that H&S tuning
devices are shipped with. Any custom downloads may result in different rat-
ings and can be found at www.hsperformance.com/update-instructions.
speed limiter
This option allows for the adjustment of the factory speed limiter. Most 6.6L LMM Duramax
trucks have a 98 MPH speed limiter from the factory. The limiter can be adjusted from 50
MPH to 95 MPH or removed completely. This option can only be adjusted during the Install
Download process.
Tire size calibration
This option allows for the re-calibration of the factory speedometer to adjust for non-stock
sized tires. For the most accurate speedometer reading when using non-stock sized tires, it
is best to measure the diameter of the tire using a tape measure rather than going by the
printed tire size. In addition, using a GPS is a great way to dial in your factory speedometer.
Entering a larger tire size will cause the factory speedometer to read higher while entering a
smaller tire size will cause the factory speedometer to read lower. The tire size can be adjust-
Power LeveLs
Stock
. . . . . . . . . . . . . . . . . . . .
0 HP
Tow
. . . . . . . . . . . . . . . . . . . .
40 HP
Street
. . . . . . . . . . . . . . . . .
80 HP
Performance
. . . .
120 HP
• 0-80 MPH @ 50% throttle position, then slow down and come to a complete stop.
• 0-80 MPH @ 100% throttle position, then slow down and come to a complete stop.
The Transmission relearn procedure is complete.
noTe: On any vehicle using 3” or larger lift blocks under the rear leaf pack, it is HIGHLY RECOMMENDED to install
traction bars when adding additional horsepower.
Maxx calibration control
Maxx Calibration Control (MCC) is an advanced engine management software tool that enables
custom tune editing with your H&S tuning device. With the power to control all aspects of engine
and transmission management, MCC gives YOU the ability to control how YOUR engine operates!
When you have exceeded the limits of conventional tuning and want to unleash the power of a
custom tune, look no further than MAXX CALIBRATION CONTROL
noTe: Applications may vary by vehicle make and model, please check our website to see if MCC is available for your
vehicle at www.hsperformance.com/mcc