H&S W3243, Руководство оператора

Страница: 27 / 36

-25-
14
Shields Removed for Clarity
4
LUBRICATION
1. (3) PTO Shaft
2. (2) Front jack shaft bearings.
3. (2) Rear Drive Shaft
4. (1) Beater
5. (2) Worm Drive Gearbox
6. (4) Side Shaft
7. (3) Side Shaft
8. (2) Tailgate Arms
9-10. (4) Axle Pivot
11. (1) Beater Clutch ControlYoke
12. (1) Two Speed Clutch Control Yoke
13. (1) Two Speed Clutch Throwout
14. (1) Rear Support Bearing
15. (4) Zerks on hubs (1 on each hub)
16. (2) Upper Beater
GREASE ZERK LOCATION - Grease every 10 hours
3 5
11 12 13
16
WHEEL BEARING LUBRICATION, CLEAN & RE-PACK INSTRUCTIONS
Wheel hubs are equipped with a grease zerk for regular maintenance. Annually disassemble and clean
parts in solvent. Reassemble bearings per instructions in the Service Chapter and tighten the castellated
nut on the spindle to the point where there is no end-play and a slight drag on the bearings. Replace the
cotter key with a new one of the correct size, bend cotter pin over and reinstall cap.