H&S HDNR 7+4, Руководство оператора / Каталог запасных частей

Страница: 47 / 60

VARIABLE SPEED BELT ADJUSTMENT
ADJUSTMENT
You should rarely have to adjust the variable speed
drive belt. If, however, it becomes necessary to adjust
the belt, follow the steps listed below:
1. Remove belt as previously instructed.
2. Move control lever to the highest apron speed
position.
3. Check upper sheaves (A), if base of sheaves are
not tight together, it is necessary to adjust.
4. Remove bolt from control rod (B).
5. Slide sheaves tight together, being sure control
yoke (C) is tight against thrust bearing and
sheaves.
6. Adjust control rod (B) so hole in control yoke and
rod align, then one additional turn.
7. Replace bolt. Allow sufficient play when tightening,
so control rod pivots.
8. Place control lever in beater disengage position
and replace belt.
A
B
LUBRICATION GUIDE
-16-
OIL
LEVEL
OIL
LEVEL
The operator should become familiar with all
lubrication points and establish a systematic rou-
tine to insure complete and quick lubrication of
the machine.
GEARBOXES – Before using your new machine,
check the oil in the main apron drive and beater
drive gearbox. Keep the main apron gearbox
filled to the oil level plug in cover of gearbox.
Beater drive gearbox should be filled to the cen-
ter of the shafts. Use 80W-90 gear lube.
DRIVE CHAINS
– Lubricate the drive chains
with a light machine oil. Keep chains aligned with
sprockets, this will lengthen the life of the sprock-
ets and chain. Lubricate chains often.
C
ITEM PART NO. DESCRIPTION
1. 5B10 1/4’’ x 1’’ Woodruff Key
2. S132 Gearbox Side Shaft
3. 3G9 Seal
4. 3G19 Snap Ring
5. 3G18 Race #15245
6. 3G7 Bearing #15101
7. 3G5 Gear
8. 3G1 Gearbox Housing
9. 3G2 Gearbox Gasket
10. 3G20 Fill Plug
11. 3G3 Cover
12. X2 Dust Cap
13. 3G11 Nut
14. 5B10 1/4’’ x 1’’ Woodruff Key
15. S134 Gearbox Front Shaft
16. S135 1/4’’ x 1-1/4’’ Square Key
17. 3G4 Nut
18. L3G24 Gearbox Bearing #15113
19. S136 Seal
* S137 Bevel Gearbox Complete
NOTE: * (Means Not Shown)
-
45
-
FIGURE 8
BEVEL GEARBOX