H&S 2217, Руководство оператора

Страница: 20 / 34

-18-
ADJUSTMENTS
DRIVE CHAIN
To adjust front drive chain, slightly loosen bolts holding pillow
block bearing at rear of front jack shaft. Loosen jam nut on
tightener rod. Turn adjusting nut (located at the right hand front
side of spreader) clockwise. There should be 1/2” deflection at
the center of the drive chain. Overtightening or too loose of a
chain will result in excessive wear on the bearing, chain and
sprockets. Retighten bolts holding bearing. Recheck chain
tension. Retighten jam nut.
BEARING
Shields Removed For Clarity
TIGHTENER BOLT
ATTACHING CHAIN TURNBUCKLE
Shields
Removed
for
Clarity
APRON SPEED AND BEATER CONTROL
One cable controls the beater and apron drive two speed gearbox. To compensate for wear or stretching
of this cable, adjust the turnbuckle behind shield at left hand front of spreader.
Refer to drawing at right to properly adjust manure
spreader. Position speed control in HI Speed.
Measurement (A) is 2-1/2 inches.
This is factory set and should not be changed. Do not
move bracket or collar on control rod. The distance
between collar and face of gearbox should be as
follows for the different speeds: (distance B)
LO Speed: 0” (tight against gearbox)
HI Speed: 7/16 -1/2”
CLEAN OUT: 3/4-1 1/16”
If collar on control rod does not pull tight to gearbox
in LO Speed, after HI Speed has been properly ad -
justed, apply more tension to return spring behind
shield at right hand front of spreader. To adjust spring,
hook end of spring one chain link shorter on spring
attaching chain.