-23-
GREASE FITTINGS
There are numerous
grease fittings on the Rake, and 1 on the Center Kicker Wheel. Lubricating properly
and often enough will prolong the life of your rake. Grease daily during normal use and before and after
storage and after power washing. Use a good grade of high-quality grease. Make sure that grease comes
out around the shaft on sleeve type bearings. Wipe off excessive grease to prevent accumulation of chaff
or grit around the bearing.
Replace any missing or plugged grease fittings.
Become familiar with all lubrication points and establish a routine to ensure complete
lubrication of the rake.
GENERAL INFORMATION
IMPORTANT:
Catch and dispose of fluid per local waste disposal regulations whenever service is performed
on hydraulic components, valves, cylinders, hoses, etc.
WHEEL BEARING LUBRICATION, CLEAN & REPACK INSTRUCTIONS
Grease wheel bearings as needed depending on amount of travel.
Annually disassemble and clean parts in a solvent. Pack bearings
with a high grade grease. Reassemble, and tighten nut until a slight
drag is felt when wheel is turned. Back nut off and insert cotter pin
into first hole that you see as you back the nut off, bend cotter pin
over and reinstall cap.
LUBRICATION
LOCATION
Listed and shown are the description of location and number of grease fittings.
Zerk
Center kicker wheel arm
(If Equipped)
Содержание 2108
