This manual is for the exclusive use of licensees and employees of McDonald’s Systems Inc.
Page 6 of 18
Revision A
Operating Instructions
Temperature Setting
The 87050.01P has been tested and preset at the factory to maintain a Product
temperature between 33ºF (0°C) and 40ºF (5°C). The temperature controller located on
the front panel displays the internal temperature of the refrigerator.
To view current set point or if the temperature is not reading within the range specified
above, the electronic controller can be adjusted using the following procedure:
Controller
Info / Setpoint button
Increase / Manual activation
button
Manual defrost / Decrease button
Exit / Stand-by button
Operating Procedure
Start-Up:
The refrigerator is turned ON by 1) plugging the cord into a Wall outlet. 2)
Turn power switch (located back left side) of refrigerator to ON . The evaporator
fan will run immediately, the compressor & the condenser fan will run after 1 minute
delay. Let the unit run for 30 minutes before placing product in the refrigerator.
Temperature Setting:
The unit has been tested at the factory and the control has been
preset to maintain a Product temperature between 33° and 40°F (0° and 5°C).
HYS is Factory set to 3°
Condensate Disposal:
The condensate from the refrigerator is disposed via a drain to
a condensate evaporator located in the base of the condensing unit.
Set point
(Display and modification of desired temperature value)
Press button “
i
” key and hold for more than 1/2 second, to display set point value
By keeping button “
i
” pressed, use button
and
to set the desired value
When button “
i
” is released, the new value is stored.
