11.
Install the motor arm on the wheelchair. See
section
5.2.5.
5.2.5.
Install a motor arm
Preparation
Make sure that the rubber suspension is installed on the carrier.
Procedure
1.
Put the motor cable through the carrier.
Do not connect it yet.
2.
Hold the motor arm (D) and carefully slide it
inward on the carrier.
•
Make sure that the rubber suspension
(F) fits into the gap on the motor arm.
3.
Fasten screw (E) to secure the rubber
suspension.
4.
Fasten the motor arm to the carrier frame.
Use some Loctite 648 to secure the screw
(B).
5.
Connect the motor cable to the
interconnection of the power module.
E
E
C B A
F
D
5.2.6.
Replace a drive wheel
Preparation
See section
5.1.
Procedure
1.
Lift the wheelchair until the wheels are free from the floor.
•
Use a lifting platform.
2.
Remove cap (A).
3.
Unfold the washer (C).
4.
Remove screw (B).
5.
Remove the old drive wheel (D) from the
motor axle.
•
Make sure that you do not loose the
key (E).
6.
Install the new drive wheel.
7.
Make sure that the drive wheel does not
interfere with the motor.
C B A
D
E
C
Maintenance tasks & adjustments
18
Service manual - Luca XL
