P600 Lift
- User Guide (753102)
Rev: 14 MAR 2017
Page: 15
The DOWN blue button located on
the front right side of the lift can be
used to lower an individual should
the hand control buttons fail. Refer
to figure 14B.
Should both DOWN arrow buttons
on the hand control, and the DOWN
button of the lift fail, the person
may be lowered by pressing the
RED emergency lowering button
located on middle front side of the
lift. There will be a delay of
approximately 2 seconds before the
lift starts to lower. An audible alarm
will also sound during the
emergency lowering.
Refer to figure 14B.
IMPORTANT:
The Emergency
Lowering system does not provide a
raising function. The failure of any
of the lowering device should be
reported to your authorized dealer
immediately.
Emergency Lowering
Figure 14B –RED emergency lowering button
located on middle of the front of the lift.
Figure 14A –Lift showing DOWN button
located on front right side of lift.
Emergency Stopping and Shut-off
The lift normally shuts off if the lift has not been in use for 2
minutes.
Should a situation present itself such that the lift will not
respond to the hand control buttons or on any of the normal opera-
tional control buttons on the front of the lift then the
RED
Emergency stop switch
should be switched to the “OFF “ po-
sition.
This will shut off power going to the motor of
the lift and will immediately stop all movement.
Should the emergency stop function be used in an emergency, then
before the lift can be used again, it must be inspected by an author-
ized dealer. Once the lift has been inspected and/or repaired, then
the Emergency Stop Button can be set to the “ON” position. Nor-
mal use of the lift may then proceed.
Note: The lift will only charge if the Emergency stop switch is in
the “ON” position. Refer to the section titled, “
Charging the lift
”
for charging instructions.
Figure 14C –RED Emergency stop switch
located on the front left side of the lift.
Figure 14D - Close-up of switch
ON - Normal lift Operation
OFF - Emergency Stop
Emergency OFF/STOP
ON
ON/OFF button on lift
