Hand Held Products Valueteam 3060, Руководство пользователя

Страница: 52 / 67

Programming the Scanner
3-38
[Data Verifier]
Scan “Program” to enter the programming mode.
Scan “Verifier Control” and set bar code symbology to
“
08 ” (Interleaved 2 of 5).
Scan “Identified Data Length” and set the length to “ 16 .”
Scan “1st Identified Character” and set the identified position to
“
00 ,” then set the identified character to “ 39 ” (Hex value for 9).
[Data Formatter]
Scan “Formatter Control” and set bar code symbology to “ 08 .”
Scan “1st Insertion” and set the identified position to “ 06 ,” then
inserted characters to “ 09 ” (Hex value for TAB), “ 53 ” (Hex value
for S), “ 4E ” (Hex value for N).
Scan “2nd Insertion” and set the identified position to “ 12 ,” then
inserted character to “ 09 .” Finally, you must scan the “ FIN ”
(Finish) code to terminate this selection.
Scan “3rd Insertion” and set the identified position to “ 16 ,” then
inserted character to “ 09 .” Finally, you must scan the “ FIN ”
(Finish) code to terminate this selection.
[Data Replacer]
Scan “Replacer Control” and set bar code symbology to “ 08 .”
Scan “1st Replacement” and set the identified position to “ 00 ,”
then replaced character to “ 41 ” (Hex value for A).
At this point the data string is as follows:
A81025[TAB]SN123456[TAB]9876[TAB]. We still need to delete
the 98 from the string to get the desired output.
[Data Organizer]
Scan “Organizer Control” and set bar code symbology to “ 08 .”
Scan “1st Organization” and set the identified position to “ 16 ,”
then set the data transmission to “ 0 ” (before).
The character position, which counts the added “SN” and TABs,
is identified as 00, 01, 02,… so the 16
th
character is “ 9 .” The
include/exclude control, which will be set to 0 for exclude in the
last step of the instructions below, determines that the “
9 ” in the
16
th
position will not be sent. All of the characters before the 16
th
position will be transmitted.
Scan “2nd Organization” and set the identified position to “ 17 ,”
which is “ 8 ,” in this case, then set the data transmission to “ 1 ”
to transmit all of the characters after position 17. Whether
position 17 gets transmitted along with the string is determined
by the include/exclude control, which, in this case, will be
excluded in the next step.
[Include/Exclude Control]
Scan “Include/Exclude Control”.
Scan “ 0 ” for transmitted data excluding the data of the identified
position.
Scan “ END ” (Exit) to terminate the programming.