Dolphin® 9500 Series Quick Start Guide
11
Verifying Radio Status
Dolphin 9500 Series terminals can be configured with 802.11b, Bluetooth™,
GSM/GPRS (Dolphin 9500 only) radios or a combination of these radios.
Radio Driver Installation
(page 1-8) after a hard reset. Only the
appropriate drivers for your terminal’s radio configuration install.
Radio Manager
The Radio Manager allows you to enable radios installed on the terminal. When
enabled, the radio is transmitting; when disabled, the radio is not transmitting.
Verify which radio is enabled after
(page 1-8) is complete. When a
single radio installs, its radio driver is enabled automatically. When more than
one radio installs, the terminal enables the 802.11b radio unless a GSM radio is
installed. Then, the terminal enables the GSM radio.
Verify the Radio Status
1. Tap Start > Settings > Connections tab > Radio Manager. The Radio
Manager opens identifying the radio modules installed in the terminal.
2. Select the radio. If the Status field says “Ready,” the radio(s) is enabled.
Radio Combinations
Co-located radios
Both radios can be installed but only
one can be operated at a time.
•
802.11b and GSM/GPRS
Co-operational radios
Both radios can operate
simultaneously.
•
Bluetooth and 802.11b
•
Bluetooth and GSM/GPRS