Assembly
2
Preparing the canopy
3
Preparing the motor
4
Assembling the fan
□
Remove the canopy ring (B) from the canopy (C).
□
Remove the two non-slotted canopy mounting screws
with lock washers (EE) from the canopy (C), and
loosen the slotted canopy mounting screws with lock
washers (EE) on the canopy (C).
□
Remove the canopy (C) from the mounting bracket (A)
by turning the canopy (C) counterclockwise.
A
EE
EE
C
B
□
Remove the cotter pin (FF), and clevis pin (GG), and
loosen the two collar setscrews (HH) from the motor
collar.
□
Route the wires exiting from the top of the fan motor
assembly (F) through the coupling cover (E). Ensure the
slot openings are on top.
□
Route the wires through the canopy (C) and then through
the hanger ball/downrod assembly (D).
□
Align the holes at the bottom of the hanger ball/downrod
assembly (D) with the holes in the collar on top of the
fan motor assembly (F).
□
Carefully insert the clevis pin (GG) through the holes in
the collar and the hanger ball/downrod assembly (D). Be
careful not to jam the clevis pin (GG) against the wiring
inside the hanger ball/downrod assembly (D).
□
Insert the cotter pin (FF) through the hole near the
end of the clevis pin (GG) until it snaps into the locked
position.
□
Tighten the two collar setscrews (HH) on top of the
fan motor assembly (F) firmly.
WARNING:
Failure to properly install the cotter pin (
FF)
could result in the fan becoming loose and possibly falling
.
9
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
NOTE:
If a longer downrod (not included) is needed, take
out the screw located in the hanger ball, lower the hanger
ball and remove the pin. Remove all three pieces from the
downrod and assemble them onto the new longer downrod
before proceeding to the downrod installation. Be sure to
snap together the 3-PIN connectors, the male plug (II) from the
fan and female plug from the extension cord (CC).
HH
HH
GG
FF
FF
C
E
HH
B
F
HH
II
D
GG
CC
