9
Installing the Light Kit
While holding the light plate under your fan,
make the polarized plug connections:
- White to white
- Blue to black
Install the light plate onto the mounting plate
with 3 screws provided. Be sure to tighten all
screws. (Fig. 16)
Install 100W halogen bulb (included).
Raise glass shade up against bottom of fan
housing and secure it to fan by turning glass
clockwise until snug.
Do not overtighten
.
(Fig. 17)
Restore power and your light kit is ready for
operation.
If the light kit does not work, turn off the
electricity and lower either canopy or decora-
tive housing on your ceiling fan to make sure
the blue wire is connected to the black house-
hold wire.
1.
2.
3.
4.
5.
6.
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
CAUTION
BEFORE STARTING INSTALLATION, DISCON-
NECT THE POWER BY TURNING OFF THE
CIRCUIT BREAKER OR REMOVING THE FUSE
AT FUSE BOX. TURNING POWER OFF USING
THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
Installing the Mounting
Plate
Remove 1 of the 3 screws from the mounting
ring and loosen the other 2 screws. (Do not
remove)
Place the key holes on the mounting plate over
the 2 screws previously loosened from the
mounting ring, turn mounting plate until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 15)
1.
2.
Moounting Plate
Mounting Ring
Screws
Figure 15
Figure 17
Figure 16
Bulb
Glass Shade
Light Plate
Mounting Plate
Light Plate
Screws
Wire Connection
