8
Assembly (continued)
4
Assembling the fan
WARNING:
Failure to properly install the cotter pin (HH) could
result in the fan loosening and possibly falling.
NOTE:
If a longer downrod (not included) is needed, take out
the screw located in the hanger ball (LL), lower the hanger ball
(LL) and remove the pin (MM). Remove all three pieces from the
downrod and assemble them onto the new longer downrod before
proceeding to the downrod installation. Be sure to snap together
the 2-pin and 3-pin connectors, the two male plugs from the
fan and female plugs from the extension cord (EE and FF).
Carefully feed the motor wires up through the downrod (NN).
Thread the downrod (NN) into the collar.
Align the holes and replace the clevis pin (II) and cotter pin
(HH). Tighten the two collar set screws (JJ).
Slip the coupling cover (E), the canopy bottom cover (C), and
the canopy (B) onto the downrod (NN).
Carefully reinstall the hanger ball (LL) onto the downrod (NN).
Being sure that the cross pin (MM) is in the correct position,
the set screw (KK) is tightened and wires are not twisted.
C
E
B
KK
MM
FF
EE
JJ
H
II
HH
JJ
LL
NN
