Screws
Lock ring
Bulbs
Light kit
assembly
Glass shade
Glass holder
Wire connection
plugs
N O T E
: B e f o r e s t a r t i n g i n s t a l l a t i o n ,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
Turning power off using the fan switch is
not sufficient to prevent electric shock.
1. Attach the light kit to the switch housing by
feeding the light kit wires (black and white)
through the hole of switch housing and then
screw it onto the switch housing by nut &
lock washer. Be sure it is tight enough to
prevent light kit from vibrating loose. (Fig.
16)
2. Locate two single white and blue wires in
the switch housing labeled FOR LIGHT.
3. Make the polarized plug connections:
- White to white
- Blue to black
4.
5. Carefully push all wires back into the
switch housing, then install the light kit
assembly onto the mounting plate with 4
screws provided. Be sure to tighten all
screws. (Fig. 17)
While holding the light kit assembly under
your fan, snap together the wire connection
plugs .
6. Remove the lock ring from the socket by
turning the lock ring counter-clockwise
Until it unlocks. Insert the glass into the
glass holder and turn the lock ring
clockwise to tighten the glass. Repeat
for the remaining glass. (Fig. 17)
7. With the power off, insert the light bulbs
(included) into the light kit sockets. Max.
60 watts.
8. Restore power and your light kit is ready
for operation.
Figure 17
Switch housing
Light kit
Nut
Lock washer
Figure 16
Installing the Light Kit
9.
NOTE:
Light bulbs have no warranty,
can be purchased at local light bulb
specialty store or from our service center.
