HAMPTON BAY Springview, Руководство пользователя

Страница: 11 / 15

Installing the light kit
REMEMBER to disconnect the power.
The fan blades must already be attached to
the fan.
Your fan and light kit though pre-wired
have been disassembled at the factory to
ease in shipping. Please follow these steps
to complete the installation of your fan and
light.
TO REDUCE THE RISK OF FIRE
D O N O T E X C E E D M A X I M U M
WATTAGE RATING.
ATTENTION: The Energy Policy Act of
2005 requires this fan to be equipped with a
190 watt limiting device. If lamping exceeds
190 watts, the ceiling fan's light kit will shut
off automatically.
1. Remove 1 of 3 screws on the mounting
ring and loosen other 2 screws. (Do not
remove)
3. Place the key holes on the mounting
p l a t e o v e r t h e 2 s c r e w s p r e v i o u s l y
loosened from the mounting ring, turn
mounting plate until it locks in place at the
narrow section of the key holes. Secure by
t i g h t e n i n g t h e 2 s c r e w s p r e v i o u s l y
loosened and the one previously removed.
(Figure 19 )
2. Remove the mounting plate from the light
kit by removing 3 screws (Keep them for
future use).
LIGHT BULB HAVE NO WARRANTY, CAN BE
P U R C H A S E D AT L O C A L L I G H T B U L B
SPECIALTY STORE OR FROM OUR SERVICE
CENTER.
4. Connect the connectors from the light
kit and fan. (Figure 19 )
5. Lift the light kit to the mounting plate,
align the key holes and tighten 3 screws
previously removed.
6. Place the 3 bulbs ( 40 Watt, included)
into the Light kits.(Figure 20)
7. Remove the two washers, metal nut,
metal cap and final from the light kit.
8. Install the glass shade, along with 2
washers previously removed, twist with
the metal nut; install the metal cap, then
twist the finial securely. (Figure 20)
9. Restore power and your ceiling fan
is ready for operations.
8
NOTE
1. Check that all blades and blade holder
screws are secure.
2. Most fan wobble problems are caused
when blade levels are unequal. Check this
level by selecting a point on the ceiling
above the tip of one of the blades. Measure
this distance as shown in Figure 18. Rotate
the fan until the next blade is positioned for
measurement. Repeat for each blade. The
distance should be equal within 1/8". Run
the fan for 10 Minutes.
3. Use the enclosed Blade Balancing Kit if
the blade wobble is still noticeable.