HAMPTON BAY SKU 776-449, Инструкция по эксплуатации

Страница: 6 / 24

Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
3ea Wire Connectors (#19) 1ea Ground Screw (#20) 1ea Hex Nut (#21)
1ea Mounting Strap (#22) 1ea Nipple (#23) 2ea Outlet Box Screws (#24)
INSTALLATION INSTRUCTIONS:
1.
Screw the Nipple (#23) a half-inch into the Mounting Strap (#22). Tighten the Hex Nut
(#21) against the Mounting Strap (#22) to secure the Nipple (#23). Attach the Mounting
Strap (#22) to the Outlet Box (#18) using the two Outlet Box Screws (#24). [Make sure the
longer end of the Nipple (#23) is facing outside when the Mounting Strap (#22) is attached
to the Outlet Box (#18).]
2.
Adjust the Chain (#3) to required height by using pliers and a screwdriver to twist open
(cover the chain with cloth to prevent damage to the link finish) the link of Chain (#3)
attached to the Loop (#5), lifting the fixture and attaching to a link closer to the ceiling. To
avoid damage to the link, only open the link enough to hook it onto another link. The
fixture can be raised and lowered in this manner until the desired height is achieved. Next,
use pliers to twist open (cover the chain with cloth to prevent damage to the link finish) the
first unused link of Chain (#3). Remove and save the excess chain. Pull the excess fixture
wires through the Nipple (#23) into the Outlet Box (#18). Wires may be left at full length
or shortened as determined by space in the Outlet Box (#18) to make the wire connections.
3. Wrap the ground wire from the fixture around the Ground Screw (#20) on the Mounting
Strap (#22), and then connect the ground wire from the fixture to the ground wire from the
Outlet Box (#18). Connect the wire without writing on it (with raised ribs) from the fixture
to the white wire (neutral wire) from the Outlet Box (#18). Connect the wire with writing
on it from the fixture to the black wire (live wire) from the Outlet Box (#21). Cover the
three connections using the three Wire Connectors (#19). Wrap the three wire connections
with electrical tape for a more secure connection. Position the wires back inside the Outlet
Box (#18).
Note: If you have electrical questions, consult your local electrical code for
approved grounding methods.
4.
Place the Canopy (#1) over the Nipple (#23) all the way to the ceiling. Tighten the Ring
(#4) onto the Screw Collar Loop (#2) until the Canopy (#1) is held firmly against the
ceiling.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the light
switch on to activate the fixture.