All blades are grouped by weight.
Because natural woods vary in density,
the fan may wobble even though the
blades are weight matched.
The following procedure should correct
most fan wobble. Check after each step.
1. Check that all blade and blade
bracket screws are secure.
2. Most fan wobble problems are
caused when blade levels are unequal.
Check this level by selecting a point on
the ceiling above the tip of one of the
blades. Measure from a point on the
center of each blade to the point on the
ceiling. Measure this distance as shown
in Figure 16. Rotate the fan until the next
blade is positioned for measurement.
Repeat for each blade. Measurements
deviation should be within 1/8". Run the
fan for 10 minutes.
3.
Use the enclosed Blade Balancing
Kit if the blade wobble is still noticeable.
9.
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT
FOREIGN OBJECTS BETWEEN ROTATING FAN
BLADES.
Installing the Light Kit
Fitter / Glass Shade
CAUTION-
To reduce the risk of
electrical shock, disconnect the electrical
supply circuit to the fan before installing
light kit
.
1. Remove the three mounting screws
and lockwashers from the black bracket
below the fan motor (Figure 17).
2. Connect the blue and white wires
exiting the black bracket of the fan
motor with the black and white wires
from the light kit fitter by connecting the
polarized plugs (blue to black ; white to
white).
Touching
ceiling
3. Align the three screw holes on the
black bracket with the holes on the top
of the light kit fitter and secure with the
screws and lockwashers that were
removed in step 1.
4. With power off , insert the halogen
bulb (Max. 50w , provided) into the
socket.
Figure 16
5. Place the glass shade into the light kit
fitter , aligning the three flat areas on the
top flange of the glass shade with the
three raised dimples in the light kit fitter
(Figure 17). Then turn the glass shade
clockwise until it stops.
NOTE: PERIODICALLY CHECK THE
GLASS SHADE IS SEATED FULLY
CLOCKWISE IN THE LIGHT KIT
FITTER.
NOTE: ALLOW THE BULBS TO
COOL COMPLETELY BEFORE
TOUCHING OR REPLACING THE
BULBS TO AVOID ACCIDENTAL
BURNING OF THE SKIN.
