HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
5
Care and Cleaning
□
Clean the light fixture with a soft, dry cloth.
□
Do not use cleaners with chemicals, solvents, or harsh abrasives.
Troubleshooting
Problem
Possible Cause
Solution
The fixture will not light.
□
There is no power.
□
There is a disconnection, or break, in the wire.
□
The transformer setting is incorrect.
□
Check the outlet and ensure that the circuit breaker or
GFCI has not been tripped.
□
Check the wire.
□
Check the transformer settings.
One light fixture flickers.
□
There is a loose wire connector.
□
Tighten the wire connector and ensure that the metal
contacts pierce the insulation on the wire from the
transformer.
All light fixtures flicker.
□
There is a loose connection at the transformer.
□
Unplug the transformer and check the wire connections.
The lights do not switch on at dusk.
□
The photocell is mounted in an area that has
too much nighttime light.
□
Install the photocell in a place with little nighttime light.
Warranty
WHAT IS COVERED
The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five (5) years from date of purchase.
The manufacturer warrants this transformer to be free from defects in materials and workmanship for a period of two (2) years from date of purchase.
This warranty applies only to the original consumer and only to products used in normal use and service. If this product is found to be defective, the
manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the
product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling.
WHAT IS NOT COVERED
This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way not in accordance with the
instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence,
alteration, or faulty installation, or any other failure not relating to faulty material or workmanship. This warranty shall not apply to the finish on any portion
of the product, such as surface and/or weathering, as this is considered normal wear and tear.
The manufacturer does not warrant and specifically disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than the
warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage,
including but not limited to any labor / expense costs involved in the replacement or repair of said product.
Contact the Customer Service Team at 1-855-HD-HAMPTON or visit www.HamptonBay.com.
FCC Warning
Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
NOTE
: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
□
Reorient or relocate the receiving antenna.
□
Increase the separation between the equipment and receiver.
□
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
□
Consult the dealer or an experienced radio/TV technician for help.
NOTE:
Most LED landscape lighting fixtures can operate with full illumination from 15V down to as little as 8V. It is possible to have extended length runs with
LED fixtures that go beyond the specifications shown in the guidelines above.
