2
Assembly and Installation (continued)
3
Installing the fixture on a surface using plastic anchors
4
Connecting the wires
□
If installation requires the plastic anchors (F), then place the cardboard
template (G) on the mounting surface and mark where the holes should
be for the self-threading screws (E).
□
At those marks, drill two 6 mm holes on the mounting surface.
□
Push the plastic anchors (F) into the two holes until the heads of the
plastic anchors (F) are flush with the mounting surface.
□
Continue the assembly using either of the applicable Step 1 procedures
on page 1.
WARNING:
The wire connector (C) contacts have sharp edges for
piercing the main low voltage cable. To avoid injury, do not touch
the metal contacts.
CAUTION:
The wire from low voltage power unit should be 12-16
AWG type underground low Energy Circuit Cable.
IMPORTANT:
□
Protect the wiring by routing it in close proximity to the light
fitting, or next to a building structure such as a house or a
deck.
□
The landscape wire and connector can also be hidden under
stone or buried under grass at a maximum depth of 6 in.
(15.24 cm).
□
Do not install the fixture within 10 ft. of a pool, spa, or fountain.
□
Do not submerge the fixture in water.
□
For the emergency use, when disconnected from the
transformer (disconnect the power supply), it can still be used
for 24 times induction.
□
Place the wire connector (C) on opposite sides of the low voltage
cable (not included) from the transformer (not included) where
the fixture will be located.
□
Align and fit the main low voltage cable vertically to the slot of
the wire connector (C).
□
Press the wire connector (C) together until it is locked around the
main low voltage cable. The pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
□
Once the wire connector (C) is in place, it is recommended to
wrap it with electrical tape (not included).
□
After all fixtures are installed, turn on the transformer.
