8
Operation (continued)
6
Selecting a push button tune
The doorbell (A) has different selectable tunes for
different push buttons (sold separately). The push
button (C) set as the “REAR” push button will only play
“Ding” (one note tune). The push button set as the
“FRONT” push button will play either “Ding-Dong” (two
note tune) or Westminster (eight note tune).
□
Press and release the “TUNE” button on the
doorbell (A) until the desired tune is heard.
NOTE:
All doorbell models are designed to work with up
to 10 wireless push buttons (sold separately).
NOTE:
All doorbells are designed to play only two
different tunes no matter how many push buttons are used.
Motion sensor
alert
Front door push button
(sold separately)
Rear door push button
(sold separately)
Doorbell tune
Beep-Beep
Ding-Dong or Westminster
Ding
Care and Cleaning
□
Use a dry cloth to clean the doorbell, sensor, and push button.
□
Do not use cleaners or polishes.
□
Do not use any fluids on the doorbell, sensor, and push button.
Troubleshooting
Problem
Possible Cause
Solution
The doorbell does
not sound.
□
The batteries are not
installed correctly.
□
Make sure the batteries are installed according to the
diagram inside the sensor and push button.
□
The batteries are dead.
□
Check the charge of the sensor and push button batter-
ies and replace them if necessary.
□
The doorbell is not
receiving power.
□
Make sure the plug-in doorbell has power.
□
The doorbell and the
sensor or push button
are not synced.
□
Sync the doorbell to the sensor or push button. Only one
sensor or push button may be synced at a time. Repeat
these steps for each sensor or push button.
□
Press and hold the button on the doorbell until the
doorbell sounds a “Beep-Beep”.
□
Press the button on the bottom of the sensor or the
push button within 30 seconds. The doorbell will
sound a “Beep-Beep” tone to indicate the sensor or
the push button is synced.
□
Test the sensor as shown in step 5 under Installa-
tion or press the push button to ensure operation.
A