5 HAMPTONBAY.com
Please contact 1-844-760-3644 for further assistance.
Installation (continued)
3
Testing the doorbell and push
button placement
□
Temporarily position the push button (B) and
doorbell (A) where they will be mounted.
□
Press the push button (B) to verify the
doorbell (A) and push button (B) work properly.
□
If the doorbell (A) does not sound, move the
doorbell (A) closer to the push button (B) and
test again.
NOTE:
Do not permanently mount the push button (B) or
doorbell (A) until they are working properly.
NOTE:
The push button and doorbell come synced from
the factory. The range of the wireless doorbell can vary
with location, temperature, and battery condition.
4
Mounting the push button
Use either screws (AA) or double-sided tape (CC) to
mount the push button (B).
□
To mount with screws (AA), remove the back
of the push button (B) by pushing in the tab
on the bottom with a small screwdriver. Place
the push button back on the door jamb and
mark the two screw holes. Drill two 1/16 in.
(1.5 mm) pilot holes. Attach with screws (AA).
□
When attaching the push button (B) with
double-sided tape (CC), remove the paper from
both sides of the double-sided tape (CC) and
apply to a clean surface.
□
Snap on the front of the push button (B).
NOTE:
Remove material in screw holes (if needed) before
mounting with screws.
5
Mounting the doorbell
Use the screws (AA) to mount the doorbell (A).
□
Determine mounting location.
□
Drill one 7/32 in. (5.5 mm) pilot hole and insert
a wall anchor (BB).
□
Insert the screw (AA) into the wall anchor (BB)
leaving about 1/8 in. (3.2 mm) of the screw
threads exposed.
□
Hang the doorbell (A) on the screws (AA) using
the keyholes on the back of the doorbell (A).
VOLUM
E
TU
NE
-HOLD
1 SE
C
SY
NC
-HOLD 3
SEC
S
RE
SE
T-HOLD
10 SEC
S
A
A
B
AA
AA
BB
