This fan comes with 3 blades, following the
below procedure for accurate installation:
Step 1. Attach the blades to the blade brackets
using the screws, nuts, metal washers and
rubber washers provided as shown in Figure 13,
be sure the jut on the blade bracket to be
positioned on the hole located on the blades
before screw installation. Starting a screw into
the bracket and blade, repeat for the other 2
screws, DO NOT tighten too much as the blades
may crack.
Step 2 Tighten each screw securely starting with
the center screw. Make sure the blade is
straight.
Step 3 Fasten the blade assemblies to the motor
following the below procedure for accurate
installation.
1. For first and second blade assemblies:
Remove the screws from the motor, attach
the first and second blade assemblies to the
motor using 3 screws provided, secured with
Allen wrench. (Figure 14)
7.
Attaching the Fan Blades
2. For third blade assembly: Remove the
screws from the motor, attach the third
blade assembly to the motor by securing 2
of 3 screws provided at first, secured with
Allen wrench. Then attach the third screw
to the motor by going through the holes on
the first blade bracket and third blade
bracket, see Figure 15.
Motor
Blade Bracket
Figure 14
Blade
Screws
Allen wrench
Motor
Blade bracket
Figure 15
Third b
lade
First b
lade
Screws
Allen wrench
Rubber washers
Blade
bracket
Figure 13
Nut
Metal washers
Blade
Screws
Jut
Hole
