7
1
Preparing the canopy
3
Assembling the fan
Preparing the motor
2
Remove the cotter pin (GG), and clevis pin (HH), and loosen
the two collar setscrews (II) from the motor collar.
Remove the canopy ring (B) from the canopy (C).
Remove the two non-slotted canopy mounting screws with
lock washers (FF) from the canopy (C), and loosen the
slotted canopy mounting screws with lock washers (FF) on
the canopy (C).
Remove the canopy (C) from the mounting bracket (A) by
turning the canopy counterclockwise.
A
FF
FF
C
B
Route the wires exiting from the top of the fan motor
assembly (G) through the coupling cover (F) and the canopy
ring (B). Ensure the slot openings are on top.
Route the wires through the canopy (C) and then through
the hanger ball/downrod assembly (E).
Align the holes at the bottom of the hanger ball/downrod
assembly (E) with the holes in the collar on top of the fan
motor assembly (G).
Carefully insert the clevis pin (HH) through the holes in the
collar and the hanger ball/downrod assembly (E). Be careful
not to jam the clevis pin (HH) against the wiring inside the
hanger ball/downrod assembly (E).
Insert the cotter pin (GG) through the hole near the end of
the clevis pin (HH) until it snaps into the locked position.
Firmly tighten the two collar setscrews (II) on top of the
fan motor assembly (G).
WARNING:
Failure to properly install the cotter pin (GG)
could result in the fan loosening and possibly falling.
Assembly — Standard Ceiling Mounting
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
G
GG
HH
II
II
G
F
II
II
HH
GG
C
B
E
JJ
DD
NOTE:
If a longer downrod is needed (not included), take out
the screw located in the hanger ball, lower the hanger ball and
remove the pin. Remove all three pieces from the downrod, and
assemble them onto the new longer downrod before proceeding
to the downrod installation. Be sure to snap together the 3-pin
connectors, the male plug (JJ) from the fan and female plug
from the extension cord (DD).
