HAMPTON BAY Cherokee 565 332, Руководство пользователя

Страница: 11 / 14

NOTE
WAIT FOR FAN TO STOP BEFORE CHANGING
THE SETTING OF THE SLIDE SWITCH .
Figure 22
Speed settings for warm or cool weather depend on
factors such as the room size, ceiling height,
number of fans, etc.
The Reverse switch is located on the top of motor
housing. Slide the switch to the Left for warm
weather operation. Slide the switch to the Right for
cool weather operation.
Warm weather - (Counter-Clockwise direction) A
downward air flow creates a cooling effect.(Fig. 22)
This allows you to set your air conditioner on a
higher setting without affecting your comfort.
Cool weather - (Clockwise direction) An upward
airflow moves warm air off the ceiling area. (Fig.
23) This allows you to set your heating unit on a
lower setting without affecting your comfort.
9
Restore power to ceiling fan and test
for proper operation.
1.
" LOW, MED, HI"
buttons:
These three buttons are used to set the fan
speed as follows:
LOW = Low speed MED = Medium speed
HI = High speed
2. "OFF" button:
This button turns the fan off.
3. The
"LIGHT" button turns the light ON or
OFF . Press and release the button to turn
the light ON or OFF.
N o t e # 1 : T h i s f a n i n c l u d e s c o m p a c t
fluorescent energy saving bulbs AKA:
CFL’s. These energy saving bulbs
cannot be dimmed and only operate
on/off.
Note
#2: If the bulbs are changed from
Figure 21
Installing the
battery:
Install 9 volt battery (not included), to
prevent damage to transmitter, remove
the battery if not used for long periods.
Figure 2 3
Figure 2 4
CFL to an incandescent standard light
bulb then the transmitter can also
operate as a dimming unit for the light
source. Simply turn off light source,
replace CFL bulbs (all of them) and
then turn back on light source to get
this feature. Again, the dimming
f e a t u r e i s o n l y a v a i l a b l e w h e n
incandescent bulbs are used.
NOTE
CFL BULB AND INCANDESCENT BULB CAN
NOT MIX-INSTALL, OR CFL WILL BE
DAMAGED.
Note #3: Dimming function detective
procedure is: When turn on the light,
there will have 2 seconds for detection
and brightness will start from 50% to
100%
If using CFL, the bightness will stay in 100%;
If using incendescent bulb, the brightness will
be back to the previous status before previous
turn-off status.