8
Attaching the light kit mounting
plate to the mounting ring
9
F
GG
WW
□
Remove one of three light kit mounting plate screws
(GG) from the mounting ring (WW) and loosen the
other two screws (GG). (Do not remove)
□
Place the key holes in the light kit mounting plate (F)
over the two screws (GG) previously loosened from
the mounting ring (WW), and turn the light kit
mounting plate (F) until the light kit mounting plate
(F) locks in place at the narrow section of the key
holes.
□
Secure by tightening the two light kit mounting plate
screws (GG) previously loosened and the one (GG)
previously removed.
Finishing the light kit assembly
and attaching the glass shades
CAUTION:
Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
12
□
While holding the light kit assembly (G) under your
fan, snap together the wire connection plugs.
□
Carefully push all wires back into the switch housing,
then install the light kit (G) assembly onto the
mounting plate (F) with the four light kit mounting
screws (HH) provided. Be sure to tighten all screws.
□
Mount the glass shades (H) to the light sockets by
unscrewing partway the three light holder
thumbscrews (II) on each glass holder. Insert the
glass shades (H), then gently tighten the
thumbscrews (II) by hand evenly to the glass shades
(H). Do not overtighten.
□
Install the 9.5W LED bulb (JJ) (included).
HH
G
H
JJ
Assembly — Installing the Light Kit
II
F