5
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly
1
Attaching the T-rock to the chair seat
2
Attaching the plastic bushing
□
Place the chair base (B) on a flat, smooth surface.
Hammer the plastic bushing (CC) into the plastic sleeve of the chair base (B) until they are at the same level.
Note to allow the small end in first.
B
CC
A
BB
GG
AA
EE
FF
DD
HH
GG
1
2
C
HH
□
□
IMPORTANT:
You
may
need
to
loosen
pre-installed
bolts
to ensure chair seat (A) and chair base (B) will line up.
IMPORTANT:
You
may
need
to
loosen the pre-installed
bolts to ensure the chair seat (A) and T-rock (C) will line up.
□
□
Fully tighten all bolts (BB) and nuts (DD) and pre-installed bolts
and nuts.
□
Cover all bolts (BB) and pre-installed bolts with bolt caps (GG).
Cover all nuts (BB) and pre-installed nuts with nut caps (HH).
Align the T-rock (C) to the U-bar (1) of the chair seat (A) from
above
the U-bar. (Viewing the chair seat when it is upside down.)
Clamp the rocking plates (2) of the T-rock (C) and the U-bar (1) of
the chair seat (A) together with washer plates (AA).
Secure the rocking plates (2), the U-bar (1) and the washer plates (AA)
with bolts (BB) from
below
the washer plates (AA), while with
washers (EE), lock washers (FF) and nuts (DD) from
above
the washer plates (AA) with spanners (II).
Place the chair seat (A) upside down on a flat, smooth surface.
□
