HAMPTON BAY Cassaro, Руководство пользователя

Страница: 13 / 18

10
Installing the Light Kit
1.
2.
3.
4.
5.
CAUTION
BEFORE STARTING INSTALLATION,
DISCONNECT THE POWER BY TURNING OFF
THE CIRCUIT BREAKER OR REMOVING THE
FUSE AT FUSE BOX. TURNING POWER OFF
USING THE FAN SWITCH IS NOT SUFFICIENT
TO PREVENT ELECTRIC SHOCK.
Mounting Plate
Wire Connectors
Light Kit Assembly
Screws
Figure 17
Remove 1 of the 3 screws from the mounting
plate and loosen the other 2 screws. (Do not
remove)
While holding the light kit under your fan,
Make the polarized plug connections: (Figure
17)
- White to white
- Black to black
Place the key holes on the light kit assembly
over the 2 screws previously loosened from the
mounting plate, turn light kit assembly until it
locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 17)
Install 3 x 40W candelabra bulbs (included).
Remove the decorative nut and glass cap from
the light kit stem. Raise the glass shade up
against the mounting plate and place the glass
cap over the light kit stem and secure it with
6.
the decorative nut. Do not overtighten. (Fig.
18)
Restore power and your light kit is ready for
operation.
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
NOTE
MAKE SURE TO LEAVE ENOUGH SPACE
BETWEEN THE FAN PULL CHAIN AND THE
BULBS SO THE CHAIN DOESN'T RUB AGAINST
ANY OF THE BULBS.
Mounting plate
Bulbs
Glass Shade
Glass Cap
Decorative Nut
Figure 18