9.
Installing the Light Kit
Screws
Light kit
Reverse
switch
Switch housing
Wire
connector
NOTE
: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power
off using the fan switch is not sufficient to
prevent electric shock.
1.
ocate two single white and blue wires in the
switch housing labeled "FOR LIGHT". Make
the polarized plug connections:
- White to white
- Blue to black
2.Carefully push all wires back into the switch
housing. Attach the light kit fitter by aligning
its keyhole slots with the three screw holes
and the reverse switch on the side of the
switch housing. Tighten the three screws
securely to prevent the light kit from
vibrating loose. (Fig. 15)
3.
nsert the glass, then gently
tighten the thumbscrews by hand evenly to the
glass. DO NOT OVER TIGHTEN. (Fig. 16)
4.Install 3 x
13 Watt compact fluorescent
bulbs (included).
NOTE:
CFL bulbs are
NOT
dimmable.
While holding the light kit under your fan,
l
Mount the glass shades to the light fixture by
unscrewing partway the thumbscrews on the
glass holders, i
Figure 15
Bulbs
Glass shade
Thumb screws
Figure 16
NOTE:
Light bulbs have no warranty; can
be purchased at any Home Depot store.
NOTE
FOR NON-LIGHT USE PURPOSE, THE SWITCH
BOX COVER IS AVAILABLE BY CALLING THE TOLL
FREE NUMBER
1-877-902-5588.
