HAMPTON BAY Bay Island, Руководство пользователя

Страница: 11 / 15

8
Fan without Light Kit
(Optional)
Disassemble the switch housing from the light
kit, you can keep the light kit for future use.
Attach the plastic plug to the switch housing.
(Fig. 15)
Holding the switch housing under your fan,
snap the wire connection plugs together .
Install the switch housing to the mounting
plate with screws provided. (Fig. 15)
1.
2.
3.
4.
While holding the light kit assembly under
your fan, snap the wire connection plugs
together (Fig. 14).
Carefully push all wires back into the switch
housing, then install the light kit assembly onto
the mounting plate with 3 screws provided. Be
sure to tighten all screws. (Fig. 14)
Install 3 x 40 watts candelabra bulbs (included)
into the light kit sockets.
NOTE: CFL bulbs
are NOT dimmable.
Remove the metal nut, metal cap and decora-
tive nut from the light kit. Place glass shade
over the light kit stem, secure with the metal
nut (rubber side on the top), metal cap and
decorative nut. Do not overtighten (Fig. 14).
Insert the 2 pull chain through the eyelet in the
shade and cap. Secure the metal cap and
decorative nut provided (Fig. 14).
1.
2.
3.
4.
5.
Restore power and your light kit is ready for
operation. 6.
Figure 14
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME DEPOT STORE.
NOTE
MAKE SURE TO LEAVE ENOUGH SPACE
BETWEEN THE FAN PULL CHAIN AND THE
BULBS SO THE CHAIN DOESN'T RUB AGAINST
ANY OF THE BULBS.
CAUTION
BEFORE STARTING INSTALLATION, DISCONNECT
THE POWER BY TURNING OFF THE CIRCUIT
BREAKER OR REMOVING THE FUSE AT FUSE
BOX. TURNING POWER OFF USING THE FAN
SWITCH IS NOT SUFFICIENT TO PREVENT
ELECTRIC SHOCK.
ATTENTION
FAN INCLUDES A 190W LIMITER TO COMPLY
WITH THE DEPARTMENT OF ENERGY 2009
REGULATION. LAMPING THIS PRODUCT OVER
190W WILL CAUSE THIS FAN TO NOT LIGHT.
PLEASE USE BULBS WITH A TOTAL WATTAGE
UNDER THE 190W REGULATION.
Screws
Pull Chain
Glass
Shade
Bulbs
Light Kit
Assembly
Metal Cap
Metal Nut
Decorative Nut
Mounting Plate
Wire Connection
Plugs
Screws
Switch Housing
Mounting Plate
Wire Connection
Plugs
Nut
Washer
Plastic Plug
Installing the Light Kit
Figure 15