5
Assembly
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
2
Attaching the leg connector bracket
3
Tightening the nuts to the bolts
□
Use the hex bolt driver (EE) to tighten all bolts (AA) and (BB).
□
Do not over tighten. Over tightening may strip bolts.
□
Cover all bolts (AA) and (BB) with covers (DD).
1
Attaching the table legs
□
Place the tabletop (A) up-side down on a flat, solid surface.
□
Attach a table leg (C) to the tabletop (A) using a 1/4 in. x
18 mm bolt (AA) and washer (CC) as shown in the diagram.
□
Guide the 1/4 in. x 18 mm bolt (AA) through the hole in the
table leg (C), and into the pre-drilled hole in the tabletop (A).
□
Hand tighten three to four turns only. (Do not tighten
completely. Some adjustments may be necessary to ensure
proper alignment of the table legs.)
□
Repeat for the other three legs.
□
Attach a leg (C) to the leg connector bracket (B) using two
1/4 in. x 28 mm bolts (BB) and washers (CC) as shown in the
diagram.
□
Guide two 1/4 in. x 28 mm bolts (BB) through the holes in the
leg connector bracket (B) into the pre-drilled holes in the
legs (C).
□
Hand tighten only.
□
Repeat for the other three legs.
A
C
FF (Preassembled)
DD
AA
CC
CC
BB
DD
B