Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1 Ground Screw (#8) 3 Wire Connectors (#11) 2 Outlet Box Screws (#7)
1 Circular Strap (#9) 2 Mounting Screws (#10) 2 Knurled Knob (#2)
INSTALLATION INSTRUCTIONS:
1.
Attach the Circular Strap (#9) to the outlet box (#12) with the two outlet box
screws (#7) as shown. The side of the Circular Strap marked “GND” must face
out.
2.
Thread the Mounting Screws (#10) into the pre-drilled holes in the Circular Strap
(#9) spaced the same distance apart as the holes in the Back-plate (#1).
3.
Connect the white wire from the fixture to the white wire from the Outlet Box
(#12), and the black wire from the fixture to the black wire from the Outlet Box
(#12). Cover the two wire connections using the two provided Wire Connectors
(#11). Wrap the two wire connections with electrical tape for a more secure
connection.
If your outlet box has a ground wire (green or bare copper), connect
fixture’s ground wire to it using the wire connector (#11). Otherwise connect the
copper ground from the fixture to Ground screw (#8) on the Circular Strap (#9).
Note: If you have electrical questions, consult your local electrical code for
approved grounding methods.
4.
Mount the body of the fixture on the wall by aligning the protruding Mounting
Screws (#10) all the way through the holes on the Backplate (#1). Be careful not
to pinch any of the wires between the fixture and the Outlet Box (#12). Tighten
the fixture to the wall by screwing the two Knurled Knobs (#2) onto the two
protruding Mounting Screws (#10).
5.
To prevent moisture from entering the outlet box and causing a short, use clear
caulking (i.e. Indoor/Outdoor Silicone Sealant) to outline the outside off fixture
back-plate where it meets the wall leaving a space at bottom to allow moisture a
means to escape.
6.
Install the proper light bulbs (not include) for your fixture. (DO NOT EXCEED
THE SPECIFIED WATTAGE!)
7.
Place Fixture Frame (#6) over Backplate (#1) and secure with Screw (#3).
8.
Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn
the light switch on to activate the fixture.
