Assembly — Standard Ceiling Mounting
9
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
1
Preparing the canopy
2
Preparing the motor
□
Remove the canopy ring (B) from the canopy (C).
□
Remove the two non-slotted screws (LL) from the
canopy (C), and loosen the slotted screws (LL) on the
canopy (C).
□
Remove the canopy (C) from the mounting bracket
(A) by turning the canopy (C) counterclockwise.
3
Assembling the fan
□
Route the wires exiting from the top of the fan motor
assembly (F) through the canopy ring (B). Ensure the
slot openings are on top.
□
Route the wires through the canopy (C) and then
through the hanger ball/downrod assembly (E).
□
Align the holes at the bottom of the hanger
ball/downrod assembly (E) with the holes in the collar
on top of the fan motor assembly (F). Carefully insert
the clevis pin (MM) through the holes in the collar
and the hanger ball/downrod assembly (E). Be careful
not to jam the clevis pin (MM) against the wiring
inside the hanger ball/downrod assembly (E).
WARNING:
Failure to properly install the cotter pin (
NN)
could result in the fan becoming loose and possibly falling
.
NOTE:
If a longer downrod is needed (not included), take
out the screw located in the hanger ball, lower the hanger
ball and remove the pin. Remove all three pieces from the
downrod and assemble them onto the new longer downrod
before proceeding step 3.
□
Remove the clevis pin (MM) and cotter pin (NN), and
loosen the two collar setscrews (OO) from the motor
collar.
□
Insert the cotter pin (NN) through the hole near the
end of the clevis pin (MM) until it snaps into the
locked position.
□
T
ighten the two collar setscrews (OO) on top of the
fan motor
assembly (F) firmly.
A
LL
LL
C
B
MM
OO
OO
NN
E
C
B
NN
OO
MM
F
