HAMPTON BAY 705 114, Руководство пользователя

Страница: 7 / 15

Hanging the Fan
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
1.
2.
3.
4. Carefully feed fan wires up through the
downrod. (Figure 8) Thread the rod into the
coupling. Next, line up holes and replace lock
pin and hitch pin. Tighten set screws.
5. Slip coupling cover, canopy cover and
canopy onto downrod. (Figure 9) Carefully
reinstall hanger ball onto rod being sure that
cross pin is in correct position, set screws are
tighten and wires are not twisted.
Secure the hanger bracket to the ceiling
outlet box with the screws and washers
provided with your outlet box. (Figure 5)
from the motor
assembly.(Figure 6)
Loosen the two set screws
6. Now lift motor assembly into position and place
hanger ball into hanger bracket. Rotate until the
check groove
rotate if this is done correctly.
drops into the registration slot and
seats firmly. (Figure 10) Downrod should not
Figure 6
Downrod
Supply
wires
Figure 8
Figure 10
Registration
slot
Figure 5
Cross pin
Hanger
ball
Downrod
Figure
7
Outlet box
Hanger bracket
Hitch pin
Lock pin
Set
screws
Motor Collar
Tighten
Screws
Firmly
Hitch Pin
Hanger ball
Ceiling
Canopy
Lock Pin
Coupling
cover
Canopy cover
Downrod
Lead Wires
Figure 9
4
Remove the hitch pin and lock pin
from downrod .Remove hanger ball from
downrod assembly by loosening set screw,
removing the cross pin,and sliding ball
off rod .
(Figure 7)