8
Natural Gas Conversion
�
�
Disconnect the gas hose from the gas valve (B).
Disconnect the gas tube (F) from the orifice elbow (G).
Remove the two M4 nuts and remove the orifice holder (I).
1
3
2
NOTE:
Natural gas conversion must be performed only
by your natural gas provider or service company.
NOTE:
NEVER USE A FLAME TO CHECK FOR LEAKS.
Stick the conversion label on the rating plate as shown below.
Replace the propane orifice (J) with the natural gas orifice
(AA) from the kit and reinstall the orifice bracket (I) by
tightening the nuts as shown in below diagram. Reconnect
and tighten the gas tube (F) to the orifice (AA). Apply a
solution of soapy water to all connections to check for
leaks. If soap bubbles continue to form, the connection has
a leak. If a leak is found, close the tank valve and tighten all
connections.
Metal Rating Plate
Serial Number _________________
Model Number: 98300
CAUTION: The gas pressure regulator provided with this appliance must be used. This regulator is set for an outlet pressure of
Minimum clearance from combustible constructions: Sides: 24 in.609 mm. Top 72 in. 1828 mm.
FOR OUTDOOR USE ONLY. If stored indoors, detach and leave cylinder outdoors.
This appliance has been converted to use Natural Gas. Input 30,000 Btu/hr.
Max Gas Supply Pressure 7 in w.c. (1.74 kPa) Min. Gas Supply Pressure 5 in w.c. (1.24 kPa)
Conversion Label
WARNING: Improper installation, adjustment alteration, service or maintenance can cause injury or
property damage. Refer to the owner’s information manual provided with this appliance. For assistance,
or additional information, consult a qualified installer, service agency, or the gas supplier.