2
Table of Contents
Table of Contents .......................................................... 2
Safety Information ......................................................... 2
Warranty ......................................................................... 4
Pre-Assembly ................................................................ 5
Planning Assembly ..................................................... 5
Tools required ............................................................ 5
Hardware Included ..................................................... 5
Package Contents ...................................................... 6
Assmebly ....................................................................... 7
Installing LP Gas Tank ............................................... 14
Checking for Leaks ..................................................... 15
Lighting Instruction ................................................... 16
Care and Maintenance ............................................... 17
Troubleshooting .......................................................... 17
Safety Information
1. The installation must conform with local codes or, in
the absence of local codes, with the National Fuel
Gas Code, ANSI Z223.1 /NFPA 54, Natural Gas and
Propane Installation Code, CSA B149.1, or Propane
Storage and Handling Code, B149.2.
2. Minimum clearance to the combustible materials is
3.61 ft. (1100 mm).
3. Perform a leak test with a soapy solution:
(a) To check gas connections.
(b) After connecting a new cylinder.
(c) Upon re-assembly after disassembly.
Please refer to the leak test procedure indicated in
this instruction manual on page 15.
Replace the hose assembly prior to the appliance
being put into operation if there is evidence of
excessive abrasion or wear, or if the hose is
damaged. The pressure regulator and hose
assembly supplied with the appliance must be used.
The replacement hose assembly / regulator shall be
that specified by the manufacturer.
4. If you don’t feel the heater is on a stable surface,
use a ground screw to fix the base of the heater on
the surface where the heater is installed. Fix the
base on an incline no wider than 15 degrees.
5. Place the propane hose with regulator assembly out
of pathways where people may trip over it or in
areas where the hose will not be subjected to
accidental damage.
6. This heater is equipped with a battery-operated
ignition device; please refer to the assembly
instructions on page 10.
7. More frequent cleaning may be required as
necessary. It is imperative that the control
compartment, burners and circulating air
passageways of the heater to kept clean.
8. Use this appliance in outdoor areas described below:
(a) With walls on all sides, but at least one
permanent opening at ground level and no overhead
cover.
(b) Within a partial enclosure that includes overhead
cover and no more than two walls. These walls may
be parallel, or at right angles to each other.
(c) Within a partial enclosure that includes overhead
cover and no more than two walls. The following
shall apply:
(i) One wall that is equivalent to at least 25% of the
total wall area is completely open.
(ii) 30% or more in total of the remaining wall area is
open and unrestricted.
9. The LP-gas supply cylinder to be used must be:
(a) Constructed and marked in accordance with the
Specifications for LP-gas cylinders of the U.S.
Department of Transportation of Dangerous Goods
and Commission, CAN/CSA-B339, as applicable;
(b) Provided with a listed overfilling prevention
device;
(c) Provided with a cylinder connection device
compatible with the connection for the appliance.
10. Disconnect the cylinder when the appliance is not in
use.
11. Storage of an appliance indoors is permissible only if
the cylinder is disconnected and removed from the
appliance.
