12
Attaching the switch housing
to the mounting ring
13
I
II
YY
□
Remove one of the three switch housing mounting
screws (II) from the mounting ring (YY) and loosen the
other two screws (II). (Do not remove)
□
Place the key holes in the switch housing (I) over the
two screws (II) previously loosened from the
mounting ring (YY), and turn switch housing (I) until
the switch housing (I) locks in place at the narrow
section of the key holes.
□
Secure by tightening the two switch housing
mounting screws (II) previously loosened and the one
(II) previously removed.
Attaching the light kit to
the switch housing
I
J
F
F
JJ
13
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
□
While holding the light kit (J) under the fan motor
assembly (F), locate two single white and blue wires
in the switch housing labeled "FOR LIGHT". Make the
polarized plug connections:
- White to white
- Blue to black
□
Carefully push all wires back into the switch housing
(I). Install the light kit (J) onto the switch housing (I)
with the three light kit mounting screws (JJ)
provided. Be sure to tighten all screws.
CAUTION:
Before starting installation, disconnect the
power by turning off the circuit breaker or removing the fuse
at the fuse box. Turning power off using the fan switch is not
sufficient to prevent electric shock.
Assembly — Installing the Light Kit
