9
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Assembly - Hanging the Fan
Attaching the fan to the electrical
box
☐
Loosen the two mounting screws (PP) in the outlet box.
☐
Pass the 120-Volt supply wires through the center hole in
the slide-on mounting bracket (A).
☐
Install the slide-on mounting bracket (A) on the outlet box by
sliding the slide-on mounting bracket (A) over the two screws
(PP) provided with the outlet box. If necessary, use leveling
washers (not included) between the slide-on mounting
bracket (A) and the outlet box. The flat side of the slide-on
mounting bracket (A) should face toward the outlet box, as
shown.
☐
Securely tighten the two mounting screws (PP).
1
WARNING:
To reduce the risk of fire, electric shock
or personal injury, mount to an outlet box marked
“Acceptable for fan support of 35 lbs. (15.9 kg) or less,”
and use the screws provided with the outlet box.
Hanging the fan
2
☐
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
☐
Insert the ball portion of the ball/downrod assembly (B) into
the socket of the slide-on mounting bracket (A).
☐
Turn the ball/downrod assembly (B) clockwise until it is
seated with the tab of the slide-on mounting bracket aligned
with the slot in the ball.
☐
If using close-to-ceiling mounting, hang the fan on the hook
provided by utilizing one of the holes at the outer rim of the
ceiling canopy (C).
NOTE:
The mounting bracket (A) is designed to slide into
place on an outlet box with the outlet box screws (PP).
WARNING:
The hook (XX) is only to balance the fan while
making the electrical connections. Failure to hang as
shown may result in the hook (XX) breaking, causing the
fan to fall. The hook must pass from the inside to the
outside of the canopy.
WARNING:
When hanging the fan on the hook (XX) it is
critical that you use one of the non-slotted (round) holes
in the canopy (C).
A
B
E
C
XX
A
C
E
D
A
PP
PP
