Light holder
Lamp
Lamp
holder
Wire
connector
Glass shade
Decorative nut
Metal plate
decorative nut
aise the glass shade up against the light holder, place the metal plate with
rubber on the top over the light holder and turn it clockwise until it locks up
against the light holder. Do not over tighten. (Fig. 15) S
ecure the decorative nut
provided
Installing the light bulb & glass shade
WARNING:
Shut off the power supply before removing or replacing lamp.
1.Remove the metal plate and
from the lightholder.
2.Connect the wire connector from the fan to the lamp, then install the
lamp (22W) to the light plate using the 3 lamp holders to prop up the
lamp. Be sure to pull the lamp holders out a little for installing the lamp
easier.(Fig.15)
3.R
.
Figure 15
9.
NOTE:
Light bulbs have no warranty, can be purchased at local light bulb
specialty store or from our service center.
