10
Assembly - Hanging the Fan (continued)
Installing the receiver
4
WARNING:
To reduce the risk of fire or electric shock,remember
to disconnect power. The electrical wiring must meet all local
and national electrical code requirements.The electrical source
and fan must be 110/120 volt, 60Hz. Do not use this product
in conjunction with any variable wallcontrol. Incorrect wire
connection can damage this receiver.
□
Position the house supply wires (AAA) to one side of the slide-
on mounting bracket (A); position the fan wires (BBB) to the
opposite side.
□
Insert the narrow end of the receiver (I) (as shown, flat side
towards the ceiling) into the slide-on mounting bracket until it
rests on top of the ball/downrod assembly.
Setting the code on the remote
control and receiver
3
CAUTION:
If other fan wires are a different color, have this
unit installed by a licensed electrician.
NOTE:
The frequencies on your receiver and hand unit have
been preset at the factory. Before installing the receiver,
make sure the dip switches on the receiver and hand unit
are set to the same frequency. The dip switches on the hand
unit are located inside the battery compartment.
NOTE:
The switch marked “O/D” controls the dimming
function of the lights. If you are using non-dimmable bulbs,
use a ballpoint pen or small screwdriver to set the switch
to “O” to disable the dimming function. If you are using
dimmable bulbs, set the switch to “D” to enable the dimming
function.
NOTE:
The battery will weaken with age and should be
replaced before leaking takes place, as battery leakage
damages the hand unit. Dispose of the used battery properly
and keep the battery out of the reach of children.
□
Remove the remote control (I) battery cover by pressing firmly
on the arrow and sliding the cover off.
□
Slide the dip switches (ZZ) to your choice of either up or down.
The factory setting is up.
□
Slide the dip switches (ZZ) on the receiver (H) to the same
position as set on the remote control (I).
□
Install two 1.5V batteries (included).
□
Replace the battery cover on the remote control (I).
□
Insert the silicone rubber stopper (OO) into the hole on the
receiver (H) to cover the dip switches.
I
H
ZZ
1
2
3
4
ON
D
O
1
2
3
4
ON
D
O
1 2
3 4
ON
OO
12
34
ON
DIP
C
B
H
BBB
AAA
A
A
WiFi antenna
CAUTION:
Do not install in a damp location or immerse in
water (for indoor use only). Do not pull on or cut leads shorter.
Do not drop or bump the unit.
NOTE:
For better performance with the WIFI system, the WIFI
antenna must be mounted to the ceiling outside of the fan’s
ceiling canopy.
