3
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION
(not included):
Ladder Gloves
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
x1 bulb re-lamping tool x1 MRC16.50W bulb
INSTALLATION:
1.
Push the top portion of the head adapter into the slot of the track section.
2.
Pull down the adapter’s locking tab.
3.
Turn “Ground Indicator” tab towards the ground groove on track to align ground
tab with ground conductor.
4.
Adapter can move to any position along the track section. Lighting fixture will
adjust to any position.
REMOVAL:
1.
Pull down the adapter’s locking tab.
2.
At the same time, rotate the adapter 90 degrees and remove from track.
INSTALLING NEW BULB OR RE-LAMPING:
1.
Turn the power off. Make sure that the bulb is cool before re-lamping the fixture.
2.
Remove the head from the track. The track head sleeve must be pulled down on
spring tab while twisting.
3.
Twist to remove bulb from the socket, Replace with new bulb using the re-
lamping tool if necessary. Keep re-lamping tool for future use.
4.
Replace the track head onto the track. Pull down the locking sleeve and lock it in
place.
CAUTION:
Please refer to the re-lamping label located on the fixture for recommended
maximum wattage.
NOTE:
This equipment has been tested and found to comply with Part 18 of the FCC
Rules. This equipment generates and can radiate radio frequency energy and if not
installed and used in accordance with the instructions and may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
1.
Re-orient or relocate the receiving antenna.
2.
Increase the distance between the equipment and receiver.
3.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4.
Do not modify or alter the unit in any way as this will result in a void of the
manufacturer’s warranty.
ASSEMBLY DIAGRAM:
CAUTION:
Adapter is designed to lock into the track section by turning adapter in one
direction only. Turn the “ground indicator” tab towards the “ground groove” on the track
to align the ground tab with the ground conductor inside the track.