Installing the Light Kit 10.
REMEMBER
to disconnect the power.
The fan blades must already be attached to
the fan
Your fan and light fixture, though pre-
wired, have been disassembled at the
factory to ease in shipping. Please follow
these steps to complete the installation of
your fan.
1. While holding the light fixture under
your fan, snap together the wire
connection plug. (Figure 17)
2. Remove screws from mounting ring
under the fan motor. Raise the light
fixture body to the mounting ring until
the holes in fixture and ring line up.
Reinsert screws to secure in place.
(Figure 17)
3. Mount the glass shades to the light
fixture by unscrewing partway the
thumbscrews on the glass holders,
i n s e r t i n g t h e g l a s s , t h e n g e n t l y
tightening the thumbscrews by hand
evenly to the glass. DO NOT OVER
TIGHTEN. (Figure 17)
4. Install 60 watt bulbs (max.). (
)
5. Restore power and your light kit is
ready for operation.
included
Thumb screws
Screws
Glass shade
Light fixture
Connection
plug
Figure 17
NOTE:
Light bulbs have no warranty,
can be purchased at local light bulb
specialty store or from our service
center.
NOTE
FOR NON-LIGHT USE PURPOSE, THE SWITCH
BOX IS AVAILABLE BY CALLING THE TOLL
FREE NUMBER 877-898-1881
3. Tuck the wire harness into the switch box.
4. Remove the screws from the mounting ring
under the fan motor. Raise the switch box to
the mounting ring until the holes in switch
box and mounting ring line up. Reinsert the
screws to secure in place.
Fan Without Light Kit
1. Disassemble the wire harness from the light
fixture, you can keep the light fixture for
future use.
2. Install the wire harness into the empty switch
box by placing the pull chain switch and
reversing switch into the holes located in the
empty switch box (see illustration), secure the
pull chain switch and reversing switch with
original nut and screws.(Fig. 18)
(Optional)
Figure 18
Nut
Pull chain
switch
Screw
Empty switch box
Wiring harness
Reversing switch
