Connector
plugs
Screws
Mounting plate
Light plate
Glass
shade
Bulbs
Mounting
plate
Figure 20
Figure 19
WARNING:
Shut off the power supply
before removing or replacing lamp. In
handling of halogen bulb, care should be
taken not to touch it with your bare hands.
Oil residue will shorten the life of the
halogen bulb. If you accidentally come
into contact, wipe thoroughly with a clean,
lint-free, cotton cloth. Allow the bulb to
cool off for 10 minutes before changing the
bulb. Use light bulb in accordance with the
fan's specification.
TO REDUCE THE
RISK OF FIRE DO NOT EXCEED
MAXIMUM WATTAGE RATING.
ATTENTION:
The Energy Policy Act of
2005 requires this fan to be equipped with
a 190 watt limiting device. If lamping
exceeds 190 watts, the ceiling fan's light
kit will shut off automatically.
Step 1.
Remove 1 of the 3 screws from the
mounting plate and loosen the other 2
screws. (Do not remove)
Step 2.
Raise and hold the light plate close
to the mounting plate and proceed to do the
wire connections. Connect the white wire
connectors from the light plate and fan,
follow the same procedure with the black
wire connectors. (Fig. 19)
Step 3.
Place the key holes on the light
p l a t e o v e r t h e 2 s c r e w s p r e v i o u s l y
loosened from the mounting plate, turn
light plate until it locks in place at the
narrow section of the key holes. Secure by
t i g h t e n i n g t h e 2 s c r e w s p r e v i o u s l y
loosened and the one previously removed.
(Fig. 19)
Step 4.
Install 2x50W halogen bulbs
(included). (Fig. 20).
Step 5.
Raise glass shade up against
bottom of fan housing and secure it to fan
by twisting glass clockwise until snug. DO
NOT OVERTIGHTEN. (Fig. 20)
10. Installing the Light Kit Assembly
