HAMPTON BAY 166 662, Руководство пользователя

Страница: 8 / 20

5
Installing the fan without arrow style
decorative downrod (with 4-1/2"
downrod) (Recommend min. 8.25 ft ceiling
height).
Remove the hanger ball from the 12" downrod
by loosening the set screw at the top of the
downrod which holds the hanger ball to the
downrod.
Slide the hanger ball down the downrod and
remove the support pin.
Reinstall the ball to the 4-1/2" downrod.
Remove the bolt, clevis pin and set screws
from the motor collar.
Route wires exiting from the motor collar
through the coupling cover, canopy cover,
canopy and then through the ball/downrod
(Fig. 6A).
Follow the steps 5 & 6 in section titled
"Hanging the Fan" for installation.
1.
2.
3.
4.
5.
6.
Figure 6A
Motor Wires
Ball/Downrod
Assembly
Ceiling Canopy
Canopy Bottom
Cover
Pin in Locked
Positioon
Motor Collar
Coupling Cover
Tighten Screw
Firmly
With 4 1/2" Downrod
Installing Fan to
the Electrical Box
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR OTHER PERSONAL INJURY.
MOUNT FAN ONLY TO AN OUTLET BOX OR
SUPPORTING SYSTEM MARKED ACCEPTABLE
FOR FAN SUPPORT AND USE THE MOUNTING
SCREWS PROVIDED WITH THE OUTLET BOX.
Cotter Pin
Clevis Pin
Figure 7
UL Listed Outlet Box
Ceiling Mounting
Bracket
120V
Wires
Mounting
Screws
(Supplied
with Electrical Box)
Tab
Pass the 120-volt supply wires through the
center hole in the ceiling mounting bracket as
shown in Figure 7.
Install the ceiling mounting bracket to the
outlet box; be sure to align the holes in the
hanger bracket with the post holes in the outlet
box and secure with screws and washers
provided by the outlet box (Fig. 7).
Security tighten the two mounting screws.
Seat the hanger ball in the mounting bracket
socket. Make sure the tab on the mounting
bracket socket is properly seated in the groove
in the hanger ball (Figure 8).
1.
2.
3.
4.