1
Preparing the canopy
2
Preparing the motor
3
Assembling the fan
8
Assembly
□
Remove the canopy bottom cover (C) from the canopy
(B) by turning the canopy bottom cover (C) counter-
clockwise.
□
Remove the mounting bracket (A) from the canopy (B)
by removing the non-slotted canopy mounting screw
(FF) from the bottom of the canopy (B) and loosening
the slotted canopy mounting screw (FF) a half turn
from the screw head. Next, turn the canopy (B)
counterclockwise to remove the mounting bracket (A)
from the canopy (B).
FF
A
B
C
FF
□
Remove the cotter pin (GG), and clevis pin (HH), and
loosen the two collar setscrews (II) from the motor
collar.
F
□
Route the wires exiting from the top of the fan motor
assembly (F) through the coupling cover (E) and the
canopy bottom cover (C). Ensure the slot openings are
on top.
□
Route the wires through the canopy (B) and then
through the hanger ball / downrod assembly (D).
□
Align the holes at the bottom of the hanger ball/down-
rod assembly (D) with the holes in the collar on top of
the fan motor assembly (F).
□
Carefully insert the clevis pin (HH) through the holes in
the collar and the hanger ball / downrod assembly (D).
Be careful not to jam the clevis pin (HH) against the
wiring inside the hanger ball / downrod assembly (D).
□
Insert the cotter pin (GG) through the hole near the
end of the clevis pin (HH) until it snaps into the locked
position.
□
Tighten the two collar setscrews (II) on top of the fan
motor
assembly (F) firmly.
WARNING:
Failure to properly install the cotter pin (GG)
could result in the fan loosening and possibly falling.
C
E
F
D
B
II
NOTE:
If a longer downrod is needed (not included), take
out the screw located in the hanger ball, lower the hanger
ball and remove the pin. Remove all three pieces from the
downrod, and assemble them onto the new longer downrod
before proceeding to step 3.
GG
HH
GG
HH
II
II
II
