Assembly — Standard Ceiling Mounting
9
1
Preparing the canopy
2
Preparing the motor
□
Remove the canopy ring (B) from the canopy (C).
□
Remove the two non-slotted canopy mounting screws
with lock washers (EE) from the canopy (C), and
loosen the slotted canopy mounting screws with lock
washers (EE) on the canopy (C).
□
Remove the canopy (C) from the mounting bracket (A)
by turning the canopy (C) counterclockwise.
3
Assembling the fan
□
Route the wires exiting from the top of the fan motor
assembly (G) through the coupling cover (F) and
canopy ring (B). Ensure the slot openings are on top.
□
Route the wires through the canopy (C) and then
through the hanger ball / downrod assembly (E).
□
Align the holes at the bottom of the hanger ball/
downrod assembly (E) with the holes in the collar on
top of the fan motor assembly (G). Carefully insert the
clevis pin (FF) through the holes in the collar and the
hanger ball / downrod assembly (E). Be careful not to
jam the clevis pin (FF) against the wiring inside the
hanger ball / downrod assembly (E).
□
Insert the cotter pin (GG) through the hole near the
end of the clevis pin (FF) until it snaps into the locked
position.
□
T
ighten the two collar setscrews (HH) on top of the
fan motor
assembly (G) firmly.
WARNING:
Failure to properly install the cotter pin (GG)
could result in the fan becoming loose and possibly falling
.
NOTE:
If a longer downrod is needed (not included), take out
the screw located in the hanger ball, lower the hanger ball
and remove the pin. Remove all three pieces from the
downrod, and assemble them onto the new longer downrod
before proceeding step 3.
E
C
B
F
G
□
Remove the clevis pin (FF), and cotter pin (GG), and
loosen the two collar setscrews (HH) from the motor
collar.
A
EE
EE
C
B
FF
HH
HH
GG
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
GG
FF
HH
HH
