5 HAMPTONBAY.com
Please contact 1-844-760-3644 for further assistance.
Installation (continued)
3
Testing the doorbell and push
button placement
□
Temporarily position the push button (B) and
doorbell (A) where they will be mounted.
□
Press the push button (B) to verify the
doorbell (A) and push button (B) work properly.
□
If the doorbell (A) does not sound, move the
doorbell (A) closer to the push button (B) and
test again.
NOTE:
Do not permanently mount the push button or
doorbell until they are working properly.
NOTE:
The push button and doorbell come synced from
the factory. The range of the wireless doorbell can vary
with location, temperature, and battery condition.
4
Mounting the push button
Use either screws (AA) or double-sided tape (CC) to
mount the push button (B).
□
To mount with screws (AA), remove the back
of the push button (B) by pushing in the tab
on the bottom with a small screwdriver. Place
the push button back on the door jamb and
mark the two screw holes. Drill two 1/16 in.
(1.5 mm) pilot holes. Attach with screws (AA).
□
When attaching the push button (B) with
double-sided tape (CC), remove the paper from
both sides of the double-sided tape (CC) and
apply to a clean surface.
□
Snap on the front of the push button (B).
NOTE:
Remove material in screw holes (if needed) before
mounting with screws.
5
Mounting the doorbell
Use one of the screws (AA) and wall anchors (BB) to
mount the doorbell (A).
□
Determine mounting location.
□
Drill 7/32 in. pilot hole and insert wall anchor
(BB).
□
Insert the screw (AA) into the wall leaving
about 1/8 in. of the screw threads exposed.
□
Hang the doorbell (A) on the screw (AA) using
the keyhole on the back of the doorbell (A).
TUNE
– HO
LD
1 S
ECON
D.
SYNC
– HO
LD
3 S
ECON
DS.
RESE
T – H
OLD
10 S
ECON
DS.
A
A
B
AA
AA
BB
