7
Installation (continued)
10
11
□
Connecting the stake
Attach the stake (E) to the bottom of the fixture housing (B).
B
E
□
CAUTION:
DO NOT use a hammer.
into the ground. For ground with hard soil, use a
trowel (not included) to loosen soil.
D
G
C
12
13
Connecting the wires
□
Detach and place the wire connector (D) on opposite sides of the low voltage cable (G) from the power pack (F) where the fixture
will be located.
□
□
□
Press the wire connector (D) together until it is locked around the main low voltage cable. Pre-set prongs will pierce the cable
insulation and establish contact with the electrical wire inside.
Align and fit the main low voltage cable vertically to the slot of the wire connector (D).
Once the wire connector is in place, wrap it with electrical tape
(not included)
for additional protection.
10ft
3m
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
