14
□
Important - Make sure the gas bottle is placed level within the base.
□
Should you need to change the gas bottle, confirm the gas supply is turned off at the regulator or bottle / cylinder valve, and there
are no sources of ignition (cigarettes, open flame, sparks, etc.) near before proceeding.
□
Inspect the gas hose to ensure it is free from any twisting or tension. The hose should hang freely with no bends, folds, or kinks
that could obstruct free flow of gas. Always inspect the hose for cuts, cracks, or excessive wear before use. If the hose is damaged,
it must be replaced with hose suitable for use with LP Gas.
CONNECTING TO THE CYLINDER
□
Confirm all control knobs are in the off position.
□
Connect the regulator to the gas bottle according to your regulator and bottle dealers instructions.
USE INSTRUCTIONS
□
Before proceeding make sure you understand the warnings section of this manual.
□
This patio heater shall be used only in a well ventilated space and shall not be used in a building, garage or any other enclosed
area.
□
This patio heater may be installed in shelter no more inclusive than; with walls on all sides but with no overhead cover, within a
partial enclosure which includes an overhead cover and no more than two side walls (these side walls may be parallel, as in a
breezeway or at right angles to each other), within a partial enclosure which includes an overhead cover and three side walls, as
long as 30% or more of the horizontal periphery of the enclosure is permanently open.
LIGHTING INSTRUCTIONS
□
Turn on the gas supply at the cylinder.
□
Push the dial in and turn to position .
□
While the dial is held pressed in at position , press the spark button repeatedly to ignite the heater.
□
Hold the dial in for at least 10 seconds to ensure the heater stays lit.
□
If the heater does not light after holding in the dial in for 20 seconds wait 5 minutes and try again.
□
Do not continuously hold the dial in as you may cause a build up of gas.
□
In windy conditions, shield from wind to ensure easy lighting and hold the dial in for at least 20 seconds to ensure the heater stays
lit.
□
Turn the control dial to high or low flame position as required.
□
Correct operation of the heater is indicated by a predominantly blue, quiet flame.
□
If the sparker fails, you can light your patio heater using a match. To light your patio heater with a match: 1. Place the lit match
through the gap below the burner mesh and wind guard. 2. Turn the control dial to the position. After the burner ignites, keep
the control dial held in for 10 seconds to ensure the burner stays lit and then release. 3. If the burner does not light after holding
the control dial in for 20 seconds with the lit match in position, remove the match, turn the control dial to the off position, wait 5
minutes and then repeat.
TO TURN OFF
□
Push the dial in and turn to position .
□
Turn the gas off and disconnect at the cylinder when not in use.
Operation (continued)
Содержание 1002693243
Страница 17: ......
