Hampshire Controls Corporation
20 Mar. 2021
MPS Operating Manual
Page 17
The setup page is a simple HTML form where you can
define the network parameters (other than the IP
address), the SMTP server information, the email
contact list username and password, the time zone,
Daylight Saving Time information, and the hour to
send the daily report.
If you change the network parameters to comply with
your on-site network, you will then need to configure
the appropriate IP address in the
Edit*SETUP*
menu, and reset the MPS (press-and-hold the
TEST/RESET button until the backlight and LEDs
turn off), prior to attempting to connect to the web
pages again using the newly assigned IP address from
computers on your local network.
The Daylight Saving Time start and end dates will
need to be updated on an annual basis after DST ends
in November and before it starts again in March.
Sun. Mar. 14, 2021 – Sun. Nov. 7, 2021
Sun. Mar. 13, 2022 – Sun. Nov. 6, 2022
Sun. Mar. 12, 2023 – Sun. Nov. 5, 2023
Sun. Mar. 10, 2024 – Sun. Nov. 3, 2024
Sun. Mar. 9, 2025 – Sun. Nov. 2, 2025
The final configuration step is to add
email addresses to the contact list.
To access the email list configuration
page, click the “Edit Contact List”
hyperlink on the main web page.
You will be prompted for a username
and password. Both of these values
are defined in the setup.html page.
The default username is “listadmin”
with the password “idoemaillist”.
The email contact list page is a
simple HTML form with locations
for up to 8 email addresses, as shown
to the left.
The 1
st
entry will get both daily reports and any alert notifications and should be a “true” email
address that goes to an email account. Should you also want to receive alerts as text messages
(SMS), you may configure any of the other entries with your 10-digit mobile phone number and
your providers’ email-to-SMS gateway (e.g. [email protected]). Contact your service
provider for the gateway name.
