6
ATTENTION!
Place the device on top of a solid, even, safe and stable surface that
tolerates the weight. Level it back and forth. Then leave it side to side.
Do not
place the appliance on top of an flammable surface (such as: table
cloth, carpet, etc.).
You must not leave the appliance near open fireplaces, electric ovens,
electric heaters or other heat sources.
Position the device appropriately so that the plug is always accessible.
Make sure liquids
don’t
get into the electrical system nor the switch. Dry off
the device thoroughly.
When you receive the product, the glass is packed separately inside the
chamber.
Assemble the shelving system and fit the front and rear sliding doors as
indicated below:
G
lass sliding Doors:
The unit has front and rear sliding doors. When unpacking, note that the
longer doors fit at the front / sloped section. The doors are fitted by placing
the door into the channel in the top section of the unit first, pushing the
glass far enough up to enable the bottom of the door to clear the bottom
channel and drop down into position in the corresponding bottom
channel. There are two channels which allow the glass doors to slide past
one another. Ensure that the handles are toward the outside of the unit.
Fit the rear doors in the same manner. There are two plastic blocks
supplied, which if placed in the bottom channels in front of the glass will
prevent the doors from opening.
Shelving system:
There are four upright channels which locate into slots provided inside the
unit. The channels have a flat tab at each end, the top side is slightly
longer. Place the channel vertically into the slot provided in the top of the
unit and then drop down to fit through the corresponding slot in the
bottom. Ensure that flat sides are facing inside the unit. The shelf support
angles fit into the slots in the upright channel.
They can be positioned level or slopping forward according to preference.
The wire shelf is positioned on top of the support angle and fits against the
securing tab at the rear of the support angle which prevents the shelf from
sliding forward.
Installation and connection